6600-722, 6600-289, 6600-042 Sweetwater, Sundance® Spas Circuit Board

Sundance® Spas used the same board on different series but sometimes would change the eprom on the board to function on a different system, but not the part number on the board. So the part number on the board may be incorrect. This is essential in getting the correct board is to look at the eprom. This is a small 1/4 inch by 1 inch (approx) on the board itself with a white sticker that started with REV. This is crucial to ordering the correct board, see info below in making the correct choice, if unsure then send a picture of the board with the eprom number visible. Also if your year and model is not listed below it is probably not for your spa. If you have the wrong eprom you can order the correct one on our site.

Comes with a latest eprom logic chip. Software revision's in the past: 5.0 5.03, 5.52, 5.54, 5.57 No Circulation Pump. If your circuit board has a Software Chip that begins with a 5, then this is the correct series board. Sundance® Spas has revised this chip several times, we send you the board with the current chip. If you have an older board with a Circulation pump, then you need a board with a Series Chip that starts with a 3 such as the 6600-286

To help clarify, your system runs its heat and filtration and jets from the main spa pump not a small circulation pump (see 6000-125 for picture of a circulation pump)

6600-722, 6600-724, 6600-042, 6600-044, 6600-289 are the same boards with different eprom chips.

Used on these Sundance® Spas Models without a Circulation Pump:

• 2017+ 680 1-pump Prado and Prado 5
  

• 2006+ 680 1-Pump: Denali® and Tacoma®

• 2003-2005 Del Sol Redondo and Hermosa

• 2000-2002 Sweetwater Board: Aruba, Bali, and Cyprus

• Replaces 6600-082, 2000-2001 Sweetwater Board: 2000-2001 Aruba, Bali, and Cyprus and 6600-089 Circuit Board.

• Replaces LX-10 Series 3-60-0098

• Replaces 6600-289, 6600-042 with eprom logic chip 5.+
  

Jacuzzi® Spas Circuit Board for:

• J-210

• J-220

We ship out the latest version of this board.

Confirms UV counter settings.
The Circuit Board must have the jumpers configured on the board to the settings on your spa, also the programming for your spa needs to be done. See the links below for the wiring schematic with jumper settings and programming instructions:

• Jumper 1-2: With Jumper on: 15Amp (if system is 120 Volt only). 30Amp (if system is a 4 wire 120/240 Volt system) 40Amp (if system is a 4 wire 120/240 Volt system)

• Jumper 3-4: With Jumper on: 2 jet pumps (do not confuse the small Circ pump as 1 pump). Without Jumper: 1 Jet pump

• Jumper 7-8: With Jumper on: Centigrade. With Jumper off : Fahrenheit Readout on panel.

Click Here to download wiring schematic (PDF)
Important: New Board Revision Programing Instructions (PDF)

 This Sundance® Spas Circuit Board is returnable for warranty only, please note our Return Policy!

Additional Information

For All Sundance® Spas and Sweetwater Circuit Boards, Click Here!

We ship select Sundance® Spas parts with FREE GROUND SHIPPING with a $4.95 handling fee on all orders. ( Contiguous U.S. only). Please see our Shipping Policy!